International Journal on Advanced Science, Engineering and Information Technology, Vol. 2 (2012) No. 3, pages: 207-210, DOI:10.18517/ijaseit.2.3.187

Improvement of Machinability of Mild Steel during Turning Operation by Magnetic Cutting

Anayet U. Patwari, M. N. Mahmood, M. D. Arif

Abstract

This paper presents the details of improvement of machinability of mild steel using magnetic cutting during turning operation. Improvement of machinability was evaluated in terms of tool life, surface roughness and chip morphology. Machine tool chatter is a type of intensive self-excited vibrations of individual components of Machine-Tool-Fixture-Work (MTFW) system. Chatter causes unwanted excessive vibratory motion in between the tool and the work-piece causing adverse effects on the product quality and machine-tool and tool life. In addition to the damage of the work-piece surface due to chatter marks, the occurrence of severe chatter results in many adverse effects, which include poor dimensional accuracy of the work-piece, reduction of tool life, and damage to the machine. Chatter is formed as resonance phenomena during machining because of the instability of the closed-loop system formed by machine tool structure and metal-cutting process. In this study, magnets were used to avoid the chatter formation zone and its effect on machinability was investigated. Improvements in tool life and surface finish were observed during magnetic cutting of the mild steel. An obvious change in the chip behaviour was also present. These observations further enhance the possibility of using this magnetic cutting to eliminate the chatter formation zones and hence eliminate the adverse effect of chatter on machinability.

Keywords:

Magnetic cutting; tool wear; surface roughness; turning operation; chip morpholog

Viewed: 1058 times (since abstract online)

cite this paper     download