Development of an Electrostatic Air Filtration System Using Fuzzy Logic Control

Dewi Nurhaji Meivita (1), Muhammad Rivai (2), Astria Nur Irfansyah (3)
(1) Institut Teknologi Sepuluh Nopember
(2) Institut Teknologi Sepuluh Nopember
(3) Institut Teknologi Sepuluh Nopember
Fulltext View | Download
How to cite (IJASEIT) :
Meivita, Dewi Nurhaji, et al. “Development of an Electrostatic Air Filtration System Using Fuzzy Logic Control”. International Journal on Advanced Science, Engineering and Information Technology, vol. 8, no. 4, Aug. 2018, pp. 1284-9, doi:10.18517/ijaseit.8.4.6512.
Particulate matter is one of the factors that can affect air quality. The air quality can be determined by the Air Pollution Index, which has several parameters including PM10 and ozone (O3). Air pollution can be overcome by using a filtration system based on electrostatic precipitation when particles are attached to the static charges. In this study, we have developed a prototype of electrostatic filter based on fuzzy logic control to reduce air pollution of particulate matters. The electrostatic filter is an ozone generator consisting of plate-type corona discharge and a high voltage dc generator. The experimental results showed that the more ozone generators used as electrostatic filters, the faster the particulate concentration decreases. However, the use of ozone generators may increase the concentration of ozone in the air that can be harmful to human health. Therefore, we have developed an electrostatic precipitation-based air pollution control using fuzzy logic. Semiconductor gas sensor and laser dust sensor are used as feedback signals for the system in regulating the amount of charges released by ozone generators. Implementation of this control system can reduce the particulates of PM10 by 80% within 10 minutes while maintaining a low level of ozone during air purification process.

Avendano, G.O., Cruz, J.C.D., Ballado, A.H., Ulyezes, L.G.R., Atienza, A.C.P., Regala, B.J.G., Uy, R.C., 2017. Microcontroller and App-Based Air Quality Monitoring System for Particulate Matter 2.5 (PM2.5) and Particulate Mater 1 (PM1). In: 2017 IEEE 9th International Conference on Humanoid, Nanotechnology, Information Technology, Communication and Control, Environment and Management (HNICEM).

Caya, M.V.C., Babila, A.P., Bais, A.M.M., Im, S.J.V., Maramba, R., 2017. Air Pollution and Particulate Matter Detector Using Raspberry Pi IoT Based Notification. In: 2017 IEEE 9th International Conference on Humanoid, Nanotechnology, Information Technology, Communication and Control, Environment and Management (HNICEM).

Wardoyo, A.Y.P., Budianto, A., 2017. A DC Electrostatic Filtering System for PM2.5 Motorcycle Emission. In: 2017 International Seminar on Sensor, Instrumentation, Measurement and Metrology (ISSIM), Surabaya, Indonesia, pp. 51-54.

Panuwastak, W., Duanden, P., 2016. Fabrication of Ozone Generator for Indor Air Quality. In: The Management and Innovation Technology International Conference (MITiCON-2016), pp. 1-3.

Reguig, A., Bendaoud, A., Bouteffaha, A., Boudra, H., Tilmatine, A., Dascalescu, L., 2017. In: Ground-Shielded Dual-Type High-Voltage Electrode for Corona Charging Applications. In: IEEE Transactions on Industry Applications, Vol. 53, No. 2, pp. 1439-1445.

Patil, J.G., Vijayan, T., 2010. Characteristic of high-Tension-Induced Corona-Discharge Plasma in Ozone Generator Diode. In: IEEE Transactions on Plasma Science, Vol. 38, No. 9, pp. 2422-2427.

Radi., Rivai, M., Purnomo, M.H., 2016. Study on Electronic-Nose-Based Quality Monitoring System for Coffee Under Roasting. In: Jurnal of Circuit, System and Computers, Vol. 25, No. 10.

Dorsey, J.A., Davidson, J.H., 1994. Ozone Production in Electrostatic Air Cleaners with Contaminated Electrodes. In: IEEE Transactions on Industry Applications, Vol. 30, No. 2, pp. 370-376.

Pontiga, F., Soria, C., Castellanos, A., Skalny, J.D., 2002. Physico-chemical modelling of negative corona in oxygen: the effect of boundaries. In: 2002 Annual report Conference on Electrical Insulation and Dielectric Phenomena, pp. 797-800.

Nur, M., Restiwijaya, M., Winarni, T.A., 2014. Dielectric Barrier Discharge Plasma Reactor Analysis as Ozone Generator. In: 2014 International Symposium on Technology Management and Emerging Technologies (ISTMET 2014), Bandung, Indonesia, pp. 129-132.

Jones, T.B., 2005. Electromechanics of Particles. In : Cambidge University Press, pp. 1-10.

A.G, Vozlimov., R.Yu, Ilimbetov., D.V, Astafev., 2016. Theoretical and Experimental Studies of the Effectiveness of an Electrostatic Air Cleaning Filter. In: 2016 2nd International Conference on Industrial Engineering, Applications and Manufacturing (ICIEAM).

Rivai, M., Rendyansyah, Purwanto, D., 2015. Implementation of Fuzzy Logic Control in Robot Arm for Searching Location of Gas Leak. In: 2015 International Seminar on Intelligent Technology and Its Applications, pp. 69-74.

Rivai, M., Sambodho, K., H, Purnomo D., 2014. Identification of Levee Strength for Early Warning System Using Fuzzy Logic. In: 2014 International Conference on Information, Communication Technology and System, pp. 25-30.

Authors who publish with this journal agree to the following terms:

    1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
    2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
    3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).