DOI : https://doi.org/10.18517/ijaseit.10.5.7224

A Spectral and Energy Efficiency of Adaptive Modulation (AM) with Power Control in Wireless Sensor Network

Subuh Pramono (1), Muhammad Hamka Ibrahim (2), Mercy Bientri Yunindanova (3)
(1) Department of Electrical Engineering, Universitas Sebelas Maret, Jl. Ir.Sutami 36A Jebres, Surakarta, 57126, Indonesia
(2) Department of Electrical Engineering, Universitas Sebelas Maret, Jl. Ir.Sutami 36A Jebres, Surakarta, 57126, Indonesia
(3) Department of Agrotechnology, Universitas Sebelas Maret, Jl. Ir.Sutami 36A Jebres, Surakarta, 57126, Indonesia
Fulltext View | Download
How to cite (IJASEIT) :
Pramono, Subuh, et al. “A Spectral and Energy Efficiency of Adaptive Modulation (AM) With Power Control in Wireless Sensor Network”. International Journal on Advanced Science, Engineering and Information Technology, vol. 10, no. 5, Oct. 2020, pp. 1906-12, doi:10.18517/ijaseit.10.5.7224.
Citation Format :
This paper presents a combination of power control and adaptive modulation performance in wireless sensor networks (WSN). WSN comprised numerous smart and small sensor nodes with limited power, memory, and processing. Furthermore, there is an impairment wireless channel between the sensor node and the coordinator node. Energy and spectral efficiency are essential issues in WSN. These two targets can be reached by applying a combination of power control and adaptive modulation. This work proposes a power control system to determine the modulation level through feedback SNR value of instantaneous wireless channel condition. The modulation level continuously changed based on the wireless channel condition. This adaptive modulation increases spectral efficiency. A better channel condition will drive to switch into a higher modulation level and vice versa. The result shows that the existence of power control can increase by about 9% of spectral efficiency than a system without power control. The system without power control just has a 91 % of selection probability, while the system equipped with power control creates a 100 % selection probability at the same of modulation level (16 QAM). Besides, combining power control with adaptive modulation also adjusts transmitting power at sensor nodes so that the effective use of transmitting power at the sensor node can be achieved. Combining power control and adaptive modulation can decrease the power consumption, enlarge the spectral efficiency with specific target bit error rate (BER), reduce the interference level, and significantly improve the WSN system performance.

H.I. Kobo, A. M. A. Mahfouz, and G. P. Hancke, “A Survey on Software-Defined Wireless Sensor Networks: Challenges and Design Requirements,” IEEE Access, vol. 5, pp. 1872-1899, Feb. 2017.

D. S. Kim, B. J. Chung, and S. Y. Son, “Implementation of a Low-Cost Energy and Environment Monitoring System Based on a Hybrid Wireless Sensor Network,” Journal of Sensors, vol. 2017, pp. 1-11, Jul. 2017.

R. Zeng, T. Liu, X. T. Yu, and Z. Zhang, “Novel Channel Quality Indicator Prediction Scheme for Adaptive Modulation and Coding in High Mobility Environments,” IEEE Access, vol. 7, pp. 11543-11553, Jan. 2019.

J. Zhang and R. Yan, “Centralized Energy-Efficient Clustering Routing Protocol for Mobile Nodes in Wireless Sensor Networks,” IEEE Communications Letters, vol. 23, no. 7, pp. 1215-1218, May 2019.

K. Li, W. Ni, L. Duan, M. Abolhasan, and J. Niu, “Wireless Power Transfer and Data Collection in Wireless Sensor Networks,” IEEE Transactions on Vehicular Technology, vol. 67, no. 3, pp. 2686-2697, Mar. 2018.

B. Jan, H. Farman, H. Javed, B. Montrucchio, M. Khan and S. Ali, “Energy Efficient Hierarchical Clustering Approaches in Wireless Sensor Networks: A Survey,” Journal Wireless Communications and Mobile Computing, vol. 2017, pp.1-14, Oct. 2017.

I. Ez-zazi, M. Arioua, A. El Oualkadi, and P. Lorenz, “On The Performance of Adaptive Coding Schemes for Energy Efficient and Reliable Clustered Wireless Sensor Networks,” Ad Hoc Networks, vol. 64, pp. 99-111, Sept. 2017.

M. A. M. Hassanien, P. Loskot, S. M. Al-Shehri, T. Numanoǧlu, and M. Mert, “Design and Performance Evaluation of Bitwise Retransmission Schemes in Wireless Sensor Networks,” Physical Communication, vol. 37, pp. 1-15, Dec. 2019.

P. Kaythry and K. Rajendiran, “Energy Efï¬cient Quasi Cyclic FEC for Wireless Sensor Networks,” Applied Mathematics & Information Sciences, vol. 11, no. 6, pp.1815-1824, Nov. 2017.

M. Kang, D. K. Noh, and I. Yoon, “Energy-Aware Control of Error Correction Rate for Solar-Powered Wireless Sensor Networks,” Sensors, vol. 18, no. 8, pp. 1-18, Aug. 2018.

W. Jiao, H. Ding, H. Wu, and G. Yu, “Spectrum Efficiency of Jointing Adaptive Modulation Coding and Truncated ARQ With QoS Constraints,” IEEE Access, vol. 6, pp. 46915-46925, Aug. 2018.

H. Teng, X. Liu, A. Liu, H. Shen, C. Huang, and T. Wang, “Adaptive Transmission Power Control for Reliable Data Forwarding in Sensor Based Networks,” Wireless Communications and Mobile Computing, vol. 2018, pp.1-22, Mar. 2018.

S. Pramono and Sugihartono, “Three, Four Transmit Antennas Space Time Block Coded MIMO in Rayleigh Fading Channel: Performance Results,” in Proc. International Conference on System Engineering and Technology, Sept. 2012, pp.1-4.

S. Ganesh, and R. Amutha, “Efï¬cient and Secure Routing Protocol for Wireless Sensor Networks through Optimal Power Control and Optimal Handoff-Based Recovery Mechanism,” Journal of Computer Networks and Communications, vol. 2012, pp.1-8, Aug. 2012.

R. Muthalagu, “Transceiver Design for MIMO Systems with Individual Transmit Power Constraints,” International Journal of Electrical and Computer Engineering, vol. 8, no. 3, pp.1583-1595, Jun. 2018.

Authors who publish with this journal agree to the following terms:

    1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
    2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
    3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).